Standardized generic DTCTransmission

P0803 — 1–4 Upshift (Skip Shift) Solenoid Control Circuit

P0803 is the standardized powertrain DTC for “1–4 Upshift (Skip Shift) Solenoid Control Circuit.” The code identifies the monitored condition; it does not by itself prove which part failed.

Standardized generic definition

1–4 Upshift (Skip Shift) Solenoid Control Circuit

DTC category

Transmission

Diagnostic priority

Usually moderate, but severity depends on the system controlled by the circuit.

Copy code

What P0803 means

P0803 is the standardized powertrain DTC for “1–4 Upshift (Skip Shift) Solenoid Control Circuit.” The code identifies the monitored condition; it does not by itself prove which part failed.

Start with the stored data and the simplest external checks before replacing the component named in the code.

Possible symptoms

Check Engine Light
Affected system may be disabled or operate intermittently
Symptoms can change with vibration, heat, or moisture

Causes to test

These are diagnostic possibilities, not a statistical parts-replacement ranking. Vehicle-specific service information takes priority.

Open circuit, short to ground, or short to voltage
Loose, corroded, spread, or water-intruded connector terminals
Failed sensor/solenoid/relay/actuator
Missing power, ground, or reference voltage
Control-module driver fault after external causes are ruled out

Step-by-step diagnostic workflow

Use the code wording to determine whether the fault is circuit/open, low, high, range/performance, or intermittent.
Inspect connector pin fit, harness rub points, heat damage, and grounds.
Verify supply voltage/reference and ground under load, not only with the circuit disconnected.
Check signal/control voltage while commanding or operating the component.
Repair wiring/terminal issues before replacing the component or module.
Clear codes only after repair, then complete an appropriate drive cycle and verify the code and symptoms do not return.

Preserve evidence: EPA OBD guidance emphasizes that stored DTCs and freeze-frame data are important to proper diagnosis. Save them before clearing codes.

Scan data worth checking

Commanded versus actual state
Reference/supply voltage where available
Intermittent history and freeze-frame conditions

Severity and drivability

Usually moderate, but severity depends on the system controlled by the circuit.

Stop driving and investigate immediately if there is a flashing MIL, oil-pressure warning, overheating, fuel leakage, severe misfire, major loss of power, abnormal mechanical noise, or a transmission that is slipping badly.

Common diagnostic mistakes

Replacing the component named in the code before circuit testing
Backprobing or probing connectors in ways that damage terminals
Using continuity alone without loaded voltage-drop testing

Related generic codes

P0804 — 1–4 Upshift (Skip Shift) Lamp Control CircuitP0801 — Reverse Inhibit Control Circuit MalfunctionP0805 — Clutch Position Sensor CircuitP0800 — Transfer Case Control System — MIL RequestP0806 — Clutch Position Sensor Circuit Range/PerformanceP0807 — Clutch Position Sensor Circuit Low

Source and accuracy notes

Generic DTC structure and standardized definitions are governed by SAE J2012/J2012DA. Actual enable criteria, thresholds, circuit pinouts, test values, software conditions, and repair procedures vary by vehicle. Use current OEM service information for the exact year/engine/calibration and check applicable manufacturer technical service bulletins. See the site methodology and primary-reference policy.