Computer output circuitsOBD-II DTC
P0674 diagnostics
P0674 suggests an output control issue where the PCM is not seeing the expected electrical response.
Category
Computer output circuits
Typical severity
Medium
Repair cost range
$60–$900 depending on parts and labor.
Copy code
Common symptoms
- Warning light(s) illuminated
- Intermittent drivability change
- Accessory/actuator not functioning
- Fails self-test / readiness monitor
- Check Engine Light illuminated
Likely causes (ranked)
- Connector corrosion or loose terminal
- Harness open/short to power/ground
- Failed actuator/solenoid motor
- Blown fuse or shared power feed issue
- PCM output driver issue (rare)
Step-by-step diagnostic checklist
- Confirm the code is current and capture freeze-frame data.
- Inspect connectors, grounds, and harness routing for rub-through.
- Check fuses/shared feeds for the affected circuit.
- Measure signal against spec under operating conditions.
- Repair, clear codes, and verify with a full drive cycle.
Tip: capture freeze-frame data before clearing codes. Confirm the cause with data and tests—avoid replacing parts by guesswork.
Severity and drivability
Medium. Severity varies by root cause and operating conditions.
FAQs
| What does P0674 mean? | P0674 suggests an output control issue where the PCM is not seeing the expected electrical response. |
|---|---|
| Is it safe to drive with this code? | Severity is typically Medium. Severity varies by root cause and operating conditions. |
| Should I clear the code? | Clear codes only after repairs. Clearing early can erase freeze-frame data needed for diagnosis. |
| What is the most common fix? | There is no single fix. Follow the checklist and repair the confirmed root cause, then retest. |