P0368 — Camshaft Position Sensor B Circuit High — Bank 1

What P0368 means

P0368 is the standardized powertrain DTC for “Camshaft Position Sensor B Circuit High — Bank 1.” The code identifies the monitored condition; it does not by itself prove which part failed.

Bank/sensor location note

Bank 1 is the cylinder bank containing cylinder No. 1. On an inline engine there is normally only one bank. Do not guess bank location from left/right orientation; verify the engine-specific service information.

How to interpret the code wording

“Circuit High” means the module saw voltage or a signal above its calibrated range. Depending on circuit design, test for a short to voltage, an open/poor ground, an open signal circuit, terminal problems, or a failed sensor/actuator. Use the OEM wiring diagram because “high” does not identify the failed part by itself.

Possible symptoms

• Hard start or no-start
• Stalling
• Tachometer drop-out
• Misfire or poor performance
• Check Engine Light

Causes to test

These are diagnostic possibilities, not a statistical parts-replacement ranking. Vehicle-specific service information takes priority.

• Sensor failure or incorrect air gap
• Damaged reluctor/tone wheel
• Open/short, poor connector fit, or shield/ground issue
• Timing correlation problem
• Low cranking voltage or control-module issue

Step-by-step diagnostic workflow

1. Record whether the code sets during crank, startup, or while running.
2. Check engine RPM and sync status during crank.
3. Inspect sensor wiring and connector routing near hot/moving components.
4. Use a scope when required to compare crank/cam waveform quality and correlation.
5. Inspect reluctor/tone wheel and mechanical timing if electrical tests pass.
6. Clear codes only after repair, then complete an appropriate drive cycle and verify the code and symptoms do not return.

Scan data worth checking

• Engine RPM during crank
• Cam/crank sync status
• Battery voltage during crank
• Cam/crank position PIDs where available

Severity and drivability

Moderate to high because loss of crank/cam speed/position information can cause stalling or a no-start.

Stop driving and investigate immediately if there is a flashing MIL, oil-pressure warning, overheating, fuel leakage, severe misfire, major loss of power, abnormal mechanical noise, or a transmission that is slipping badly.

Common diagnostic mistakes

• Replacing a sensor without inspecting the reluctor wheel
• Ignoring weak battery/cranking voltage
• Using resistance alone to judge an active Hall-effect sensor

Related generic codes