P0027 — Exhaust Valve Control Solenoid Circuit Range/Performance — Bank 1

What P0027 means

P0027 is the standardized powertrain DTC for “Exhaust Valve Control Solenoid Circuit Range/Performance — Bank 1.” The code identifies the monitored condition; it does not by itself prove which part failed.

Bank/sensor location note

Bank 1 is the cylinder bank containing cylinder No. 1. On an inline engine there is normally only one bank. Do not guess bank location from left/right orientation; verify the engine-specific service information.

How to interpret the code wording

“Range/Performance” usually means the signal can be electrically plausible yet disagrees with the operating condition the module expects. Check sensor bias/contamination, mechanical or hydraulic system performance, restrictions/leaks, and commanded-versus-actual data—not just continuity.

Possible symptoms

• Check Engine Light
• Affected system may be disabled or operate intermittently
• Symptoms can change with vibration, heat, or moisture

Causes to test

These are diagnostic possibilities, not a statistical parts-replacement ranking. Vehicle-specific service information takes priority.

• Open circuit, short to ground, or short to voltage
• Loose, corroded, spread, or water-intruded connector terminals
• Failed sensor/solenoid/relay/actuator
• Missing power, ground, or reference voltage
• Control-module driver fault after external causes are ruled out

Step-by-step diagnostic workflow

1. Use the code wording to determine whether the fault is circuit/open, low, high, range/performance, or intermittent.
2. Inspect connector pin fit, harness rub points, heat damage, and grounds.
3. Verify supply voltage/reference and ground under load, not only with the circuit disconnected.
4. Check signal/control voltage while commanding or operating the component.
5. Repair wiring/terminal issues before replacing the component or module.
6. Clear codes only after repair, then complete an appropriate drive cycle and verify the code and symptoms do not return.

Scan data worth checking

• Commanded versus actual state
• Reference/supply voltage where available
• Intermittent history and freeze-frame conditions

Severity and drivability

Usually moderate, but severity depends on the system controlled by the circuit.

Stop driving and investigate immediately if there is a flashing MIL, oil-pressure warning, overheating, fuel leakage, severe misfire, major loss of power, abnormal mechanical noise, or a transmission that is slipping badly.

Common diagnostic mistakes

• Replacing the component named in the code before circuit testing
• Backprobing or probing connectors in ways that damage terminals
• Using continuity alone without loaded voltage-drop testing

Related generic codes